|
开发板固化程序到NAND FLASH: L6 x! U- [! s% D$ G
加载和运行烧写程序nand-writer.out出现NAND flashing failed!错误
" c: o% R0 M0 E3 w1 O- s/ J( f# w; m* _* E3 k* s$ ^
[ARM9_0] Starting DA8xx_NANDWriter.
* Z% d/ g& e* p; sDA8XX/OMAP-L1XX part detected. Its an ARM boot device
$ X# _4 _9 v7 F' G You require two images to boot this device( e% ]2 A1 v0 _; I; r. J+ @
1) ARM UBL in AIS file format.* X# a' s6 r9 h* ?, D6 P
2) U-Boot image in raw binary format
" x# W/ k8 f1 n$ c9 S/ Z( tTo generate the AIS format file, you need to run the ARM/DSP .out (COFF) file generated from CCS build through the AISGen tool. H3 w' Y6 ^% {
ERROR: NAND Initialization failed.+ \3 J' l: ?+ L& J! Y5 }, M
! `* k A; R) o! J. I
: v0 `$ Q# t& q: m1 J. B% N$ P9 I: n4 n
NAND flashing failed!+ _4 H, w1 B5 ^
(设置从UART2启动)6 F# D: Q$ x. ]- |- K- {0 Z
- N# i+ o: E9 v, a# R% T
|
|