|
开发板固化程序到NAND FLASH3 P6 E- Q) E: g" i R& A
: ]- _& I- l1 |( z( F加载和运行烧写程序nand-writer.out出现NAND flashing failed!错误3 [; t3 c1 w$ q- ~5 n; \- Z$ u# T# Z8 J2 k, ^
; j! y6 c( Q$ Q/ w; S! D) [" p& r5 K p8 j2 v$ y/ J) U
[ARM9_0] Starting DA8xx_NANDWriter.& V: @# V/ ~6 F& c; m2 q, k
/ H" a9 B2 H+ R4 d* y. H- [- u6 }6 eDA8XX/OMAP-L1XX part detected. Its an ARM boot device
4 @5 f# \ e% B; \& f9 i+ z You require two images to boot this device- } Q% x: x3 v" V- ^% {+ g0 B6 s# Z% m# t* ~6 p/ L
1) ARM UBL in AIS file format.' ^4 |) T; [' g; i' J- [, S
2) U-Boot image in raw binary format! N3 Q: K1 }5 r j6 ?3 F5 ]9 V7 P! C+ Q
To generate the AIS format file, you need to run the ARM/DSP .out (COFF) file generated from CCS build through the AISGen tool.
2 n6 h8 g5 t8 c5 v5 @& W ERROR: NAND Initialization failed.! H4 G4 l5 s6 B0 Y0 O5 l6 }( o5 D1 `
3 C' ]! h7 G3 A1 |& S
: o) \) X* h+ x' _ ?8 {- ]% B$ w
; f# D: z( Q6 f; W- P0 a4 p$ B* ]' i2 L$ `+ X. H
) v7 R/ H# q* JNAND flashing failed!
2 e( c' l. R9 V ~. R: K T(设置从UART2启动)
( _& k8 q; S! e4 v! g这个该怎么解决呢?
) u+ c/ d) t& V+ s0 Y# j |
|