|
开发板固化程序到NAND FLASH
! y2 P$ o( V) @: E加载和运行烧写程序nand-writer.out出现NAND flashing failed!错误9 }& a3 y- [. C# w* J' P
" i9 _$ e ~4 T5 g/ d8 q
[ARM9_0] Starting DA8xx_NANDWriter.
. s7 z% z& Q$ l: PDA8XX/OMAP-L1XX part detected. Its an ARM boot device5 w4 F' u/ ?; n" M4 g
You require two images to boot this device% O# h# T: T% ~
1) ARM UBL in AIS file format.. x7 v$ }5 ~* B) G. X/ c
2) U-Boot image in raw binary format
6 T( g% {* Y' q7 E3 Y# n* u7 ZTo generate the AIS format file, you need to run the ARM/DSP .out (COFF) file generated from CCS build through the AISGen tool.
$ `' a+ m D7 E) ?# y ERROR: NAND Initialization failed.& u$ {& w7 l/ Z9 x
0 [, y9 J: p) P( ~% z& x7 L2 M
9 u3 Y' m5 F- X d( }2 c% p/ N4 W! s$ U( N) g
NAND flashing failed!, \6 }; k; n: P
(设置从UART2启动)2 a9 j: t1 k0 }. v3 g" Z
8 C0 B+ N- B$ P+ @' a |
|