|
|
开发板固化程序到NAND FLASH
* }0 D% r$ o' t6 `加载和运行烧写程序nand-writer.out出现NAND flashing failed!错误0 _9 E0 ^7 ~; q" w+ T9 q4 ]& j# _: p
/ ?) I8 V% h* R" T[ARM9_0] Starting DA8xx_NANDWriter." r1 L- q- C9 I h" p
DA8XX/OMAP-L1XX part detected. Its an ARM boot device M. |" I2 ]& G' O: E0 k
You require two images to boot this device* r8 Y& V; F+ E5 q+ Z _' ` T, L
1) ARM UBL in AIS file format.
- Z: n. U7 P- L0 K0 f; d 2) U-Boot image in raw binary format, d9 U* S3 e# d" d
To generate the AIS format file, you need to run the ARM/DSP .out (COFF) file generated from CCS build through the AISGen tool.; r2 k X8 r) R5 N8 q: A
ERROR: NAND Initialization failed.
% } {% V: P+ l3 P
# C* F4 M) V- T. Y4 t0 @ ~: U1 Q2 Q: O$ k- Q& i0 d6 \3 ~
" T/ Z; d4 [# c8 y0 n; \
NAND flashing failed!0 N4 z% `. v" |% P
（设置从UART2启动）1 v/ a' Z2 j, v- C9 g* I
5 j3 P% ]( {% d3 R D
|
|
|手机版|小黑屋|嵌入式开发者社区
( 粤ICP备15055271号 ) 
发表于 2015-10-2 09:59:38
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
收藏
淘帖
