PRU_C加载不了程序？

377711

斌总，最近在用PRU_C做一个数据接收，，但用PRU_C里的例程是，load   .out文件后就出现下面的错误是怎回事？PRU得使用单独的GEL文件？
C674X_0: Trouble Writing Memory Block at 0x0 on Page 0 of Length 0x604: (Error -1190 @ 0x0) Unable to access device memory. Verify that the memory address is in valid memory. If error persists, confirm configuration, power-cycle board, and/or try more reliable JTAG settings (e.g. lower TCLK). (Emulation package 7.0.48.0)
C674X_0: File Loader: Verification failed: Target failed to write 0x00000000
C674X_0: GEL: File: E:\Demo\PRU_C\LED\Debug\LED.out: Load failed.

广州创龙莫工

您好，您的仿真器步骤是否正确？您是怎么操作的？
仿真PRU工程，要使用光盘"\demo\PRU"目录下的Tronlong_C6748.gel替换原来的gel文件。
仿真PRU_C工程，连接DSP核成功后，继续连接PRU核。 基于PRU核，进行工程的加载和仿真即可。