求助--138启动时网络崩掉了

浩然

2 w& U4 c5 C1 Z6 k/ k如上图

1. rpcbind: cannot bind * on udp: Address already in use
   
2. rpcbind: cannot bind tcp: Address already in use
   
3. rpcbind: cannot create socket for udp6
   9 `- [* b# m1 X9 s* ^8 E2 o
4. rpcbind: cannot create socket for tcp6

复制代码

浩然

1. Configuring network interfaces... [   30.928920] davinci_mdio davinci_mdio.0: resetting idled controller
   4 E9 g. z( r" @2 V( x' J% a
2. [   30.936280] net eth0: attached PHY driver [SMSC LAN8710/LAN8720] (mii_bus:phy_addr=davinci_mdio-0:00, id=7c0f1)
   
3. udhcpc (v1.20.2) started
   
4. Sending discover...
   7 H/ l5 }' T' O1 r  ]) `  Q
5. Sending discover...
   
6. [   34.931077] PHY: davinci_mdio-0:00 - Link is Up - 100/Full
   
7. Sending discover...
   
8. No lease, failing
   % O9 a$ b% r, U. L. p- V+ z
9. done.
   
10. Starting portmap daemon...
    ; y: n1 ]  F- O9 ~6 y
11. Starting rpcbind daemon...rpcbind: cannot bind * on udp: Address already in use
    9 O* Q* k, G) L4 ]
12. rpcbind: cannot bind tcp: Address already in use
    
13. rpcbind: cannot create socket for udp6
    
14. rpcbind: cannot create socket for tcp6
    0 j' J1 P/ P5 `. {5 Y+ A- v( V
15. done.
    & S  t9 B/ O7 ~4 [' C
16. net.ipv4.conf.default.rp_filter = 1
    4 @9 O0 h5 \2 {; x: w
17. net.ipv4.conf.all.rp_filter = 1
    
18. Mon Jun  8 17:47:00 UTC 2015
    % j, J! N4 I- t5 N
19. Starting atd: OK

复制代码

6 u% M( \2 m* q; |; W5 q) q通过SD卡启动板子，一样的，不行

广州创龙廖工

您好，请问您是直连还是交叉的呢？我们默认是交叉连接，获取动态ip