|
|
开发板固化程序到NAND FLASH
$ v! I. g- A7 o1 d& i" O加载和运行烧写程序nand-writer.out出现NAND flashing failed!错误* q2 w7 z% ]1 Y2 N7 F" y
1 J' M/ R* P6 Z4 X8 @7 K! `6 _
[ARM9_0] Starting DA8xx_NANDWriter.- Y' H) a% a4 O" Y4 S3 B
DA8XX/OMAP-L1XX part detected. Its an ARM boot device! e/ O6 l3 R* I, P* b
You require two images to boot this device9 G6 N9 T7 K" |
1) ARM UBL in AIS file format.4 f/ E) \( y: i
2) U-Boot image in raw binary format2 Y3 q6 G: g: i) B/ b+ m
To generate the AIS format file, you need to run the ARM/DSP .out (COFF) file generated from CCS build through the AISGen tool.
. {3 R/ M3 [6 i: _6 w" p6 ^& E6 h ERROR: NAND Initialization failed.
# Z; h+ C( t6 f' S! s. K) P' {8 Y& |/ X, u% ^) w
# F( m* \" X3 j1 f) X/ U. s
. O O- Z* Q7 X( @$ ~" }NAND flashing failed!
) l3 d! l. a9 b% N8 [# d（设置从UART2启动）
" C" e9 ~$ J' @+ K& G$ Z3 @
: b& M+ H1 k" S z! ?; h' b |
|
|手机版|小黑屋|嵌入式开发者社区
( 粤ICP备15055271号 ) 
发表于 2015-10-2 09:59:38
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
收藏
淘帖
