开发板固化程序到NAND FLASH : o8 \: Z8 `$ ?3 d% u) z2 [加载和运行烧写程序nand-writer.out出现NAND flashing failed!错误 1 M0 W( N& k' B9 ~5 i( S) ?2 I: Q3 b. b! N
[ARM9_0] Starting DA8xx_NANDWriter.9 r0 Y% q I+ w& c4 c' W6 n1 @
DA8XX/OMAP-L1XX part detected. Its an ARM boot device$ O3 D# e9 z/ ]2 S7 f7 l- o
You require two images to boot this device5 P! v; C0 \$ w8 A; r/ @# \
1) ARM UBL in AIS file format. 3 f5 j |- {& K' e4 s" J) \* Y 2) U-Boot image in raw binary format; R/ B: F* e4 a7 L7 G6 v
To generate the AIS format file, you need to run the ARM/DSP .out (COFF) file generated from CCS build through the AISGen tool. 0 B3 m! t6 }$ t+ S R9 l8 c, H ERROR: NAND Initialization failed.- v* D2 C7 W8 V4 d1 Q/ e* t0 }6 k- M
2 Y. w2 [ j7 {0 o0 k. k" s' C! ~3 x+ x( r1 a) d( Y* Q. d/ B2 q9 x# C
' J) P6 _% ?- z
NAND flashing failed! ( ]/ H& M& v* h W4 }（设置从UART2启动）4 v( j9 i( h& H0 e
8 ?0 S6 T% g0 S0 v9 r
|手机版|小黑屋|嵌入式开发者社区
( 粤ICP备15055271号 ) 
发表于 2015-10-2 09:59:38
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
收藏
淘帖
