求助--138启动时网络崩掉了

浩然

, M' g: l8 E, e如上图

1. rpcbind: cannot bind * on udp: Address already in use
   
2. rpcbind: cannot bind tcp: Address already in use
   
3. rpcbind: cannot create socket for udp6
   
4. rpcbind: cannot create socket for tcp6

复制代码

浩然

1. Configuring network interfaces... [   30.928920] davinci_mdio davinci_mdio.0: resetting idled controller
   
2. [   30.936280] net eth0: attached PHY driver [SMSC LAN8710/LAN8720] (mii_bus:phy_addr=davinci_mdio-0:00, id=7c0f1)
   / D' ]. t) d6 c; n2 j
3. udhcpc (v1.20.2) started
   
4. Sending discover...
   * z" L0 _- V. }0 T  G6 D8 H
5. Sending discover...
   0 W; V, g  U7 C$ K' Y1 @( B
6. [   34.931077] PHY: davinci_mdio-0:00 - Link is Up - 100/Full
   . h3 s0 s' }& `  d
7. Sending discover...
   1 }6 {6 P7 w" j, D, F4 j. o
8. No lease, failing
   
9. done.
   
10. Starting portmap daemon...
    
11. Starting rpcbind daemon...rpcbind: cannot bind * on udp: Address already in use
    5 q( A  O: l5 r' K- t1 L0 T8 L) j9 D
12. rpcbind: cannot bind tcp: Address already in use
    
13. rpcbind: cannot create socket for udp6
    
14. rpcbind: cannot create socket for tcp6
    7 T  J9 S0 E% ]- p' ]
15. done.
    - R, n& G& z0 r, G* h
16. net.ipv4.conf.default.rp_filter = 1
    2 Z- v/ ~+ Q+ O9 K
17. net.ipv4.conf.all.rp_filter = 1
    / c( k/ H$ ~! ?) X, k
18. Mon Jun  8 17:47:00 UTC 2015
    * R7 N6 T5 C& z% Q: e5 a7 M
19. Starting atd: OK

复制代码

- c' N6 A# M, e通过SD卡启动板子，一样的，不行
( h7 b; y9 J  W( @

广州创龙廖工

您好，请问您是直连还是交叉的呢？我们默认是交叉连接，获取动态ip