求助--138启动时网络崩掉了

浩然

如上图
- f0 f5 l/ @. [9 @

1. rpcbind: cannot bind * on udp: Address already in use
   % t  }5 B2 Z4 L: P
2. rpcbind: cannot bind tcp: Address already in use
   . D* Y: r3 H9 s# ^6 U
3. rpcbind: cannot create socket for udp6
   
4. rpcbind: cannot create socket for tcp6

复制代码

广州创龙廖工

您好，请问您是直连还是交叉的呢？我们默认是交叉连接，获取动态ip

浩然

1. Configuring network interfaces... [   30.928920] davinci_mdio davinci_mdio.0: resetting idled controller
   + {# d7 c4 P" i9 A/ I
2. [   30.936280] net eth0: attached PHY driver [SMSC LAN8710/LAN8720] (mii_bus:phy_addr=davinci_mdio-0:00, id=7c0f1)
   . M: y2 _. K( l0 S
3. udhcpc (v1.20.2) started
   7 h4 c3 j& M4 a! K- X  `1 L& |- q
4. Sending discover...
   " S: ^, F! o* {' ?4 s9 p1 d+ Y
5. Sending discover...
   ! L. I4 G( Y' f* I: _& F* t1 M/ {
6. [   34.931077] PHY: davinci_mdio-0:00 - Link is Up - 100/Full
   2 q0 P  U* j, c8 @7 x6 G
7. Sending discover...
   
8. No lease, failing
   8 B' Z6 ]4 v. G  W) J$ p+ @' p: p
9. done.
   5 }* D; C! \; Q
10. Starting portmap daemon...
    9 [- {6 `" H$ b+ d1 z
11. Starting rpcbind daemon...rpcbind: cannot bind * on udp: Address already in use
    
12. rpcbind: cannot bind tcp: Address already in use
    9 M) u% ^% G4 C1 p4 X; N
13. rpcbind: cannot create socket for udp6
    
14. rpcbind: cannot create socket for tcp6
    
15. done.
    $ j9 y5 u, }# B/ }/ f( o
16. net.ipv4.conf.default.rp_filter = 1
    " r4 C1 B8 a. \0 S
17. net.ipv4.conf.all.rp_filter = 1
    
18. Mon Jun  8 17:47:00 UTC 2015
    0 y7 F0 ~" y2 }
19. Starting atd: OK

复制代码

! Z, A( a# s8 p
通过SD卡启动板子，一样的，不行