|
开发板固化程序到NAND FLASH3 P6 E- Q) E: g" i R& A, M& V) l: w4 v: I% d& d
加载和运行烧写程序nand-writer.out出现NAND flashing failed!错误3 [; t3 c1 w$ q- ~
A" q2 n# Q( m) x; S; j! y6 c( Q$ Q/ w; S! D& @5 }8 D5 R' q7 R( w& f
[ARM9_0] Starting DA8xx_NANDWriter.& V: @# V/ ~6 F& c; m2 q, k
" M1 [. N: M* k ^) ?/ j& BDA8XX/OMAP-L1XX part detected. Its an ARM boot device
; Q: d1 H( {* l3 s0 M8 ~/ l# ] You require two images to boot this device- } Q% x: x3 v" V- ^% {9 ]' {) l( s# j w2 X' V0 e2 U
1) ARM UBL in AIS file format.
. w/ F! g0 ~$ }- `3 V$ e3 I 2) U-Boot image in raw binary format! N3 Q: K1 }5 r j6 ?3 F
& k; ] D. Q, a G' jTo generate the AIS format file, you need to run the ARM/DSP .out (COFF) file generated from CCS build through the AISGen tool.
- W2 k9 x9 Z1 K/ c* L ERROR: NAND Initialization failed.! H4 G4 l5 s6 B0 Y
+ r. v* y& V6 X. J5 T
5 n$ f, ^- B4 N* b/ |: o) \) X* h+ x' _ ?8 {- ]% B$ w; \; K* H/ H) m8 X* F1 l
4 p$ B* ]' i2 L$ `+ X. H
6 i( M: w2 f& p, J* ]NAND flashing failed!
. x# M- _& M3 \- W(设置从UART2启动)0 k! d1 U$ h& ]$ x: Q6 D, Y
这个该怎么解决呢? Z* Z1 N% e( L; V4 \& _
|
|