|
连接电缆失败,驱动重装试过了无法解决,求大佬指导!
GUI --- Auto connect to cable...
INFO:iMPACT - Digilent Plugin: Plugin Version: 2.4.4
INFO:iMPACT - Digilent Plugin: no JTAG device was found.
AutoDetecting cable. Please wait.
*** WARNING ***: When port is set to auto detect mode, cable speed is set to default 6 MHz regardless of explicit arguments supplied for setting the baud rates
PROGRESS_START - Starting Operation.
Connecting to cable (Usb Port - USB21).
Checking cable driver.
Source driver files not found.
The Platform Cable USB is not detected. Please connect a cable.If a cable is connected, please disconnect
and reconnect to the usb port, follow the instructions in the 'Found New Hardware Wizard', then retry
the Cable Setup operation.
Cable connection failed.
Connecting to cable (Parallel Port - LPT1).
Checking cable driver.
Installing WinDriver6...Installing WinDriver6...
Installer exit code = 1.
Successful.
Cable connection failed.
Connecting to cable (Parallel Port - LPT2).
Checking cable driver.
Installing WinDriver6...Installing WinDriver6...
Installer exit code = 1.
Successful.
Cable connection failed.
Connecting to cable (Parallel Port - LPT3).
Checking cable driver.
Installing WinDriver6...Installing WinDriver6...
Installer exit code = 1.
Successful.
Cable connection failed.
Connecting to cable (Parallel Port - LPT4).
Checking cable driver.
Installing WinDriver6...Installing WinDriver6...
Installer exit code = 1.
Successful.
Cable connection failed.
PROGRESS_END - End Operation.
Elapsed time = 2 sec.
Cable autodetection failed.
WARNING:iMPACT:923 - Can not find cable, check cable setup ! |
|